Entry Conditions For The Adjustment Mode
WARNING: This page is about a different variant/trim than selected.
- Set switches to the following conditions:
- Hazard Warning Light Switch
OFF - Diagnosis Control
ON (Connect scan tool MB991502 to the data link connector, or connect the data link connector terminal No. 1 to ground.) - Key Reminder Switch
OFF (insert the ignition key) - Ignition Switch
"LOCK" (OFF) - Driver's Door Switch
OFF (driver's door closed)
- Hazard Warning Light Switch
- If the windshield washer switch remains on for 10 seconds or more, the tone alarm incorporated in the ETACS-ECU sounds once, and then enter the adjustment mode.