Data List Reference Table
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- When shifting the selector lever to "D" range, the brakes should be applied so that the vehicle does not move forward.
- Driving tests always need two persons: one driver and one observer.
NOTE:
*: Disconnect the throttle position sensor connector, and then delete the diagnostic trouble code that was recorded during the inspection with the use of scan tool MB991958 after the inspection has been completed.
DATA LIST REFERENCE TABLE MUT-III SCAN TOOL DISPLAY
| MUT-III SCAN TOOL DISPLAY | ITEM NO. | INSPECTION ITEM | INSPECTION REQUIREMENT | NORMAL CONDITION | ||
|---|---|---|---|---|---|---|
| APS SNS(MAIN) | 12 | Accelerator pedal position sensor (main) | Ignition switch: "ON" | Accelerator pedal: Released | 735 - 1,335 mV | |
| Accelerator pedal: Gradually depressed | Increases in response to the pedal depression stroke | |||||
| Accelerator pedal: Fully depressed | 4,000 mV or more | |||||
| BREAK SW | 06 | Stoplight switch | Brake pedal: Depressed | ON | ||
| Brake pedal: Released | OFF | |||||
| CANCEL CODE | 13 | Cancel code | Ignition switch: "ON" | The cancel code, which set when the auto-cruise control system was cancelled at the last time, is set again. | ||
| CANCEL SWITCH | 04 | Auto-cruise control switch | CANCEL | "CANCEL" switch: ON | ON | |
| "CANCEL" switch: OFF | OFF | |||||
| CLUTCH SW | 07 | Clutch pedal positon switch < M/T > | Clutch pedal: Depressed | ON | ||
| Clutch pedal: Released | OFF | |||||
| Transmission range switch < A/T > | Transmission range switch: "P" or "N" | ON | ||||
| Transmission range switch: Other than above | OFF | |||||
| CRUISE | 09 | Auto-cruise control operation | Auto-cruise control: active | ON | ||
| Auto-cruise control: Inactive | OFF | |||||
| IDLE SW SIG | 08 | Accelerator pedal position switch | Accelerator pedal: Depressed | OFF | ||
| Accelerator pedal: Released | ON | |||||
| MAIN SW | 01 | Auto-cruise control switch | CRUISE (MAIN) | "CRUISE" (MAIN) switch: "ON" | ON | |
| "CRUISE" (MAIN) switch: "OFF" | OFF | |||||
| RESUME SWITCH | 03 | Auto-cruise control switch | ACC/RES | "ACC/RES" switch: ON | ON | |
| "ACC/RES" switch: OFF | OFF | |||||
| SET SWITCH | 02 | Auto-cruise control switch | COAST/SET | "COAST/SET" switch: ON | ON | |
| "COAST/SET" switch: OFF | OFF | |||||
| STOPLIGHT SW | 05 | Stoplight switch | Brake pedal: Depressed | ON | ||
| Brake pedal: Released | OFF | |||||
| TP SNSR(MAIN) | 11 | Throttle position sensor (main)* |
|
Fully close the throttle valve with your finger | 300 - 700 mV | |
| Fully open the throttle valve with your finger | 4,000 mV or more | |||||
| No load | 520 - 620 mV | |||||
| Selector lever: "N" to "D" | 540 - 640 mV | |||||
| VSS | 10 | Vehicle speed signal | Road test the vehicle | The speedometer and scan tool MB991958 display the same value. | ||