LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Body >> Sunroof >> Module/Frame Assembly >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Module/Frame Assembly: Removal

  1. Move glass panel to fully closed position.
  2. Disconnect and isolate negative battery cable.
  3. Remove control switch. (Refer to BODY/SUNROOF/REMOVAL )
  4. Remove headliner. (Refer to INTERIOR/HEADLINER - REMOVAL )
    Fig 1: Removing/Installing Sunroof Module Assembly
    G04857191Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Disconnect wire harness push in fasteners electrical connector from vehicle harness.
  6. Disconnect drain tubes from sunroof housing.
  7. Cut foam support pad at rear of module if necessary.
  8. Remove two module side bracket bolts (2) and loosen the six remaining fasteners.
  9. With the aid of a helper, remove the six (2) fasteners attaching sunroof module assembly (1) to roof panel.
  10. Remove the glass panel. (Refer to BODY/SUNROOF/REMOVAL )
  11. Remove the sunshade. (Refer to BODY/SUNROOF/REMOVAL )
  12. Remove the drive motor. (Refer to BODY/SUNROOF/MOTOR W/CONTROL UNIT - REMOVAL )
  13. Remove the wire harness.
  14. Remove the sight shields.
  15. Remove the trough guides. (Refer to BODY/SUNROOF/GUIDE-TROUGH ASSEMBLY - REMOVAL )
scientia non olet · About LEMON Manuals