LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2008 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Auto-Cruise Control - Lancer Evolution) >> Auto-Cruise Control >> On-Vehicle Service >> Cruise Control System Component Check >> Stoplight Switch Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stoplight Switch Check

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the stoplight switch harness connector.
  2. Check for continuity between the terminals of the switch.
    TERMINAL CONNECTOR AND SPECIFIED CONDITION

    Measurement condition Terminal connector of tester Specified condition
    When brake pedal is depressed. 1 - 2 (for stoplight switch) Continuity (less than 2 ohms)
    3 - 4 (for brake switch) Open circuit
    When brake pedal is not depressed. 1 - 2 (for stoplight switch) Open circuit
    3 - 4 (for brake switch) Continuity (less than 2 ohms)
    Fig 1: Identifying Stoplight Switch And Brake Pedal Assembly
    G05393813Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals