LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2008 >> Lancer Evolution GSR >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Auto-Cruise Control - Lancer Evolution >> Auto-Cruise Control >> On-Vehicle Service >> Cruise Control System Component Check >> Cruise Control Switch Check
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Cruise Control Switch Check

  1. Remove the cruise control switch (Refer to REMOVAL AND INSTALLATION  ).
  2. Measure the resistance between terminal number 2 and terminal number 3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
    Fig 1: Checking Cruise Control Switch
    G05393812Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    TERMINAL CONNECTOR AND SPECIFIED CONDITION

    Terminal connector of tester Switch position Specified condition
    2 - 3 All switches are released. Open circuit
    "ON/OFF" switch is pressed Continuity (less than 2 ohms)
    "CANCEL" switch is pressed 202.5 - 208 Ω
    "COAST/SET" switch is pressed 610.5 - 624.5 Ω
    "ACC/RES" switch is pressed 1838 - 1877 Ω
  3. Check for continuity between the between terminal number 1 and terminal number 4 of the cruise control switch.
    TERMINAL CONNECTOR AND SPECIFIED CONDITION

    Terminal connector of tester Specified condition
    1 - 4 Continuity (less than 2 ohms)
scientia non olet · About LEMON Manuals