LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2008 >> Lancer Evolution MR >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Auto-Cruise Control - Lancer Evolution >> Auto-Cruise Control >> Auto-Cruise Control System Diagnosis >> Data List Reference Table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List Reference Table

CAUTION:
  • Driving tests always need two people: one driver and one observer.
  • When shifting the shift lever to "D" range the brakes should be applied so that the vehicle does not move forward.
DATA LIST REFERENCE CHART

Scan tool display Item number Inspection item Inspection requirement Normal condition
APP sensor (main) 11 Accelerator pedal position sensor (main) Ignition switch: "ON" Accelerator pedal: Released 900 - 1,100 mV
Accelerator pedal: Gradually depressed Increases in response to the pedal depression stroke
Accelerator pedal: Fully depressed 4,000 mV or more
Brake light switch 74 Stoplight switch Brake pedal: Depressed ON
Brake pedal: Released OFF
Cancel code 57 Cancel code Ignition switch: "ON" The cancel code, which set when the cruise control system was cancelled at the last time.
Cancel switch 75 Cruise control switch CANCEL "CANCEL" switch: Pressed ON
"CANCEL" switch: Released OFF
Clutch switch 78 Clutch switch < M/T > Clutch pedal: Depressed ON
Clutch pedal: Released OFF
Cruise control 81 Cruise control system operation Cruise control system: active ON
Cruise control system: Inactive OFF
Main switch 86 Cruise control switch ON/OFF "ON/OFF" switch: Pressed ON
"ON/OFF" switch: Pressed again OFF
Neutral switch 87 Shift lever position < TC-SST > Shift lever: "N", "P", "R" position ON
Shift lever: Other than "N", "P", "R" position OFF
Normally closed brake switch 89 Stoplight switch (brake switch) Brake pedal: Depressed ON
Brake pedal: Released OFF
Resume switch 91 Cruise control switch ACC/RES "ACC/RES" switch: Pressed ON
"ACC/RES" switch: Released OFF
Set switch 92 Cruise control switch COAST/SET "COAST/SET" switch: Pressed ON
"COAST/SET" switch: Released OFF
TP sensor (main) 13 Throttle position sensor (main)(1)
  • Remove the intake air hose at the throttle body.
  • Disconnect the TP sensor connector, and then connect terminals 3, 4, 5 and 6 with the use of the special tool: MB991658 (Test harness).
  • Ignition switch: "ON"
 Fully close the throttle valve with your finger 300 - 700 mV
Fully open the throttle valve with your finger 4,000 mV or more
No load 500 - 660 mV
A/C switch: "OFF" to "ON" Voltage rises
Shift lever: "N" to "D" Voltage rises
Vehicle speed 4 Vehicle speed signal Road test the vehicle The speedometer and scan tool MB991958 display the same value.
(1) After the inspection is completed, disconnect the TP sensor connector, and then delete the DTC using scan tool MB991958 (Refer to HOW TO READ AND ERASE DIAGNOSTIC TROUBLE CODE ).
scientia non olet · About LEMON Manuals