Cruise Control Switch Check
- Remove the cruise control switch (Refer to REMOVAL AND INSTALLATION ).
- Measure the resistance between terminal number 2 and terminal number 3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.TERMINAL CONNECTOR AND SPECIFIED CONDITION
Terminal connector of tester Switch position Specified condition 2 - 3 All switches are released. Open circuit "ON/OFF" switch is pressed Continuity (less than 2 ohms) "CANCEL" switch is pressed 202.5 - 208 Ω "COAST/SET" switch is pressed 610.5 - 624.5 Ω "ACC/RES" switch is pressed 1838 - 1877 Ω - Check for continuity between the between terminal number 1 and terminal number 4 of the cruise control switch.TERMINAL CONNECTOR AND SPECIFIED CONDITION
Terminal connector of tester Specified condition 1 - 4 Continuity (less than 2 ohms)