Module - Anti-Lock Brakes: Installation

NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type, refer to REAR AXLE - 8 1/4 or REAR AXLE - 9 1/4 . For tire revolutions per mile, refer to WHEEL AND TIRE . To program the ABM refer, to the Appropriate Diagnostic Service Information.

Fig 1: Identifying Pump Electrical Connector And HCU

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Position the module (1) on the HCU (2).

Fig 2: Identifying Module Mounting Screws, HCU And Pump Electrical Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the mounting screws (1) and tighten to 6 N.m (53 in. lbs).
Install the pump electrical connector (3) to the module (4).
Install the HCU to the vehicle. Refer to INSTALLATION .