Remote Start Antenna Module: Installation

Fig 1: Identifying Remote Start Antenna Module

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The Remote Start Antenna Module Assembly consists of an electrical connection to the WCM/SKREEM (1), a length of coax cable (2), two mounting clips (3) and (4), and a control module/antenna (5)  .

Fig 2: Identifying WCM/SKREEM, Coax Cable, Mounting Clips And Control Module/Antenna

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

1. Fish coax cable (1) through openings on top of instrument panel. Position module (2) to top of instrument panel.
   Fig 3: Identifying WCM/SKREEM, Coax Cable, Mounting Clips And Control Module

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Install two module mounting screws (4) to module (3).
   Fig 4: Identifying Module Mounting Screws

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Connect coax cable retainers (3) and (4) to instrument panel.
   Fig 5: Identifying Coax Cable Retainers And IP

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. Connect coax cable electrical connector (2) to WCM/SKREEM.
5. Install WCM/SKREEM to steering column (1).
6. Clip upper instrument panel (IP) bezel (defroster).
7. Install left A-pillar trim.
8. Install IP cluster and its three connectors.
9. Install IP cluster bezel.
10. Install left IP end cap.
11. Install steering column trim panel (knee blocker).
12. Install steering column shrouds.
13. Connect negative battery cable.