Registration Using Scan Tool MB991958 (M.U.T.-III Sub Assembly): Notes
WARNING: This page is about a different variant/trim than selected.
Required Special Tools:
- MB991958 Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827 M.U.T.-III USB Cable
- MB991910 M.U.T.-III Main Harness A
The ID codes necessary for the engine immobilizer system, the keyless entry system and the TPMS can be registered using the scan tool MB991958 (M.U.T.-III sub assembly). KOS and keyless operation key are indicated as F.A.S.T and F.A.S.T.-key respectively in the scan tool MB991958 (M.U.T.-III sub assembly) screen.
CAUTION:
If the ignition key with transmitter is added or replaced, register the key (key ID), and then register the keyless ID again.
CAUTION:
Do not register the ignition key registered for other vehicles.