Dismounting/Mounting Procedures: Notes
CAUTION:
The tire should be dismounted from the wheel using the tire changer manufacturer's instructions.
CAUTION:
The use of non-genuine wheels may cause the improper installation of tire pressure sensors, possibly resulting in air leakage and damage to sensor.
NOTE:
If the spare tire valve is not positioned as shown, the roll switch (which is incorporated in tire pressure sensor) may operate. In that case, the system may determine the spare tire as a road tire incorrectly. See Fig 1.
NOTE:
If a TPM system tire pressure sensor, receiver, antenna or feeder cable(s) is replaced, the tire pressure sensors must be registered. See RESET PROCEDURES .
NOTE:
Ensure valve cap is always in place except when adjusting tire pressure. If the valve core and valve cap are replaced, use a genuine replacement part. The valve core is similar to a conventional one, but uses nickel plating to avoid corrosion.