>>C<< Transaxle Control Cable Installation

Move the selector lever to the "N" range.
Move the manual control lever to Neutral position.
Align the hole at the end of the manual control lever and the hole in the transmission range switch body flange (section A - A).
NOTE: Insert a approx. 5 mm bar into the aligned holes in the transmission range switch body flange and on the tip of the manual control lever to position the transmission range switch body.

Fig 1: Aligning Hole At End Of Manual Control Lever And Transmission Range Switch Body Flange
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Tightening torque: 9.5 ± 3.5 N-m (84 ± 30 in-lb)
Make sure that the transaxle side ranges that are corresponding to the selector lever position operate and function without fail.

Fig 2: Adjusting Nut And Transaxle Control Cable

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.