Special Tools: Notes
WARNING: This page is about a different car, the 2020 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
| MB990767 Front hub and flange yoke holder |
MB990767-01 | Fixing of the hub | |
| MB991618 Hub bolt remover |
General service tool | Removal of the hub bolt | |
| MB992700 Lock nut chisel |
General service tool | Raising up the swaged part driveshaft nut | |
| MB991897 or MB992011 Ball joint remover |
MB991113-01, MB990635-01 or General service tool |
Knuckle and tie rod end ball joint disconnection
NOTE:
Steering linkage puller (MB990635 or MB991113) is also used to disconnect knuckle and tie rod end ball joint.
|
|
MB990241 Axle shaft puller
|
MB990241-01 or General service tool |
|
|
| MB991354 Puller body |
General service tool | ||
| MB991056 or MB991355 Knuckle arm bridge |
MB991056-01 | Removal of the hub | |
| MB992250 Knuckle arm bridge attachment |
- | Removal of the hub
NOTE:
Replace this attachment with a guide of MB991355 and use them.
|
|
| A: MB991017 B: MB990998 C: MB991000 A, B: Front hub remover and installer C: Spacer |
MB990998-01 |
|
|
| MB991099 Oil seal installer guide |
- | Measurement of hub starting torque | |
| MB990326 Preload socket |
General service tool | ||
| MD998801 Remover |
- | Removal of the wheel bearing inner race (outside) | |
| MB992150 Oil seal installer |
- | Installation of the wheel bearing inner race (outside) | |
| MD998812 Installer cap |
- | ||
| MD998813 Installer |
- | ||
| MB990925 Bearing and oil seal installer set |
MB990925-01 or General service tool | Removal of the wheel bearing | |
| MB991388 Bush remover base |
- | Installation of the dust shield | |
| MB991576 Base | - | ||
| MB990890 Rear suspension bushing base |
MB990890-01 | Installation of the wheel bearing | |
| MD999528 Adapter | - | ||
| MB991561 Boot band crimping tool |
MB991561 | BJ boot (resin boot) band installation |