Diagnostic Trouble Code Chart

WARNING: This page is about a different car, the 2020 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

During troubleshooting, a DTC associated with other system may be set when the electric motor switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are set, erase them all.
When you replace the camera-ECU, you should teach the camera-ECU for the multi-around monitor by writing a learned value. On completion, you should check the camera image on the multi around monitor "Bird's eye-view." If necessary, calibrate the camera.
When you remove/install or replace the camera, you should check the camera image on the multi around monitor "Bird's eye-view." If necessary, calibrate the camera.

DTC No.	Diagnostic item	Reference
B2501	Rear view camera fault	DTC B2501: REAR VIEW CAMERA FAULT
B2503	Nose view camera fault	DTC B2503: NOSE VIEW CAMERA FAULT
B2505	ECU internal error (EEPROM) fault	DTC B2505: ECU INTERNAL ERROR (EEPROM) FAULT
B2540	CPU fault	DTC B2540: CPU FAULT
B2541	ASIC fault	DTC B2540: CPU FAULT
B2542	SDRAM fault	DTC B2540: CPU FAULT
B2543	EEPROM fault at start up	DTC B2543: EEPROM FAULT AT START UP
B2544	Flash ROM fault	DTC B2543: EEPROM FAULT AT START UP
B2546	LH side view CAMERA fault	DTC B2543: EEPROM FAULT AT START UP
B2547	RH side view CAMERA fault	DTC B2547: RH SIDE VIEW CAMERA FAULT
B2548	Calibration not completed	DTC B2548: CALIBRATION NOT COMPLETED
B254A	Steering angle sensor fault	DTC B254A: STEERING ANGLE SENSOR FAULT
B254B	CAMERA output voltage fault	DTC B254B: CAMERA OUTPUT VOLTAGE FAULT
B254E	Camera ECU output pictures fault	DTC B254E: CAMERA ECU OUTPUT PICTURES FAULT
B254F	IG status fault	DTC B254E: CAMERA ECU OUTPUT PICTURES FAULT
U0100*	PHEV-ECU CAN timeout	DTC U0100: PHEV-ECU CAN TIMEOUT
U0141	ETACS CAN timeout	DTC U0141: ETACS CAN TIMEOUT
U0155	Meter CAN timeout	DTC U0155: METER CAN TIMEOUT
U0245	NAVI/DISP.AUDIO CAN timeout	DTC U0245: NAVI/DISP.AUDIO CAN TIMEOUT
U1195	Coding not completed	DTC U1195: CODING NOT COMPLETED
U1197	Coding data unavailable	DTC U1197: CODING DATA UNAVAILABLE

NOTE: It is referred to as "U0100 Engine CAN timeout" on scan tool (M.U.T.-IIISE).