LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2021 >> Outlander PHEV LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Multi Around Monitor) >> Symptom Procedures >> On-Vehicle Service >> Calibration error table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Calibration error table

WARNING: This page is about a different car, the 2020 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.
Item No. Item name Error contents Troubleshooting
14 Coding not comp/Setting err.flag The variant coding for the ETACS-ECU has not been implemented. Check whether DTC No. U1195 is set. If yes, diagnose the system according to the DTC.
Requirements for the calibration are not satisfied. Check whether the requirements for the calibration are satisfied.
  • Are the calibration markers positioned correctly?
  • Is a strong illumination, which a camera misinterprets as a white line on the calibration marker, emitted nearby?
15 Door open detection flag Any of the doors and liftgate are open. Check that any of the doors and liftgate are closed. If no, close the door or the liftgate.
16 Front camera error
flag		 The front-view camera does not recognize either of the calibration markers precisely.
  1. Check the vehicle conditions.
    • Are prerequisites for the calibration satisfied?
    • Is the vehicle parked in a correct position?
    • Is the camera lens contaminated?
  2. Check the calibration markers.
    • Are the calibration markers positioned correctly?
    • Are the calibration markers contaminated?
    • Is any of the calibration markers hard to see due to a sunlight refection?
  3. Repeat the calibration.
17 Rear camera error flag The rear-view camera does not recognize either of the calibration markers precisely.
18 Left side camera error flag The side-view camera (LH) does not recognize either of the calibration markers precisely.
19 Right side camera error flag The side-view camera (RH) does not recognize either of the calibration markers precisely.
20 Flash ROM writing error flag Internal malfunction of camera-ECU.
  1. Repeat the calibration.
  2. If any error code is displayed again, replace the camera-ECU (Refer to CAMERA-ECU REMOVAL AND INSTALLATION  ).
  3. Repeat the calibration.
21 SD-RAM error flag
22 EEPROM writing error flag
scientia non olet · About LEMON Manuals