Fail-Safe System Check
WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to ON position.
- Turn CRUISE ON.OFF switch to ON and check if the "SET" indicator blinks.
If The Indicator Lamp Blinks, Check The Following.
- ASCD steering switch. Refer to ASCD STEERING SWITCH CHECK .
- Drive the vehicle at more than 40 km/h (25 MPH) and push SET/COAST switch.
If The Indicator Lamp Blinks, Check The Following.
- Vehicle speed sensor. Refer to VEHICLE SPEED SENSOR CHECK .
- ASCD motor actuator circuit. Refer to ASCD MOTOR ACTUATOR CIRCUIT CHECK .
- Replace control unit.
- Drive the vehicle at more than 20 km/h (12 MPH).
If The Indicator Lamp Blinks, Check The Following.
- Replace ASCD motor actuator.
- Depress brake pedal slowly (brake pedal should be depressed more than 5 seconds).
If The Indicator Lamp Blinks, Check The Following.
- ASCD brake/stop lamp switch. Refer to ASCD BRAKE/STOP LAMP SWITCH CHECK .
- END. (System is OK.)