Consult-II Inspection Procedure: Notes

Connect "CONSULT-II and CONSULT-II CONVERTER" to the data link connector.

Fig 1: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Displaying "START (NISSAN BASED VHCL)" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM".
If "BCM" is not indicated, refer to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 3: Displaying "SELECT SYSTEM" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "RETAINED PWR".

Fig 4: Displaying "RETAINED PWR" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode.
"ACTIVE TEST" and "WORK SUPPORT" are available.

Fig 5: Displaying "ACTIVE TEST" and "WORK SUPPORT" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.