Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

Installation is basically the reverse order of removal.

CAUTION:

Replace O-rings for A/C piping with new one, then apply compressor oil to it when installing it.
Mark the mounting position of intake sensor bracket.
Connection point for female-side piping is thin. So, when inserting male-side piping, take care not to deform female-side piping. Slowly insert in axial direction.
Insert one-touch joint connection point securely until it clicks.
After piping has been connected, pull male-side piping by hand to make sure piping does not come off.
When recharging refrigerant, check for leaks.