Personal Lamp Control Does Not Operate (Room/Map Lamps Operate)

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK EACH DOOR SWITCH
Select "BCM" on CONSULT-II. With "INT LAMP" data monitor, make sure switches listed in display item list turn ON-OFF linked with switch operation. Refer to "SWITCH OPERATION " for switches and their function.

Fig 1: Identifying CONSULT II Display - DATA MONITOR

OK or NG

OK: GO TO 2.

NG: Inspect malfunctioning door switch.
CHECK PERSONAL LAMP OUTPUT
1. Turn ignition switch OFF.
2. Confirm lamp switch is in the DOOR position.
3. Disconnect personal lamp 2nd row connector.
4. Open any door.
5. Check voltage between personal lamp 2nd row harness connector R10 terminal 1 and ground.
  1 - Ground : Battery voltage should exist.
  
  Fig 2: Checking Voltage Between Connector R10 Terminal 1 And Ground
OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK PERSONAL LAMP CONTROL CIRCUIT
1. Disconnect front room/map lamp assembly connector.
2. Check continuity between front room/map lamp assembly harness connector R9 terminal 3 and personal lamp 2nd row harness connector R10 terminal 3.
  3 - 3 : Continuity should exist.
  
  Fig 3: Checking Continuity Between Connector R9 Terminal 3 And Connector R10 Terminal 3
OK or NG

OK: Replace personal lamp 2nd row.

NG: Repair harness or connector.