Hood Lock Control Inspection

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the hood lock cable is bent or deformed, replace it.

Remove the front grille. Refer to "FRONT GRILLE ".
Check that the secondary latch is properly engaged with the secondary striker with hood's own weight by dropping it from approx. 200 mm (7.87 in) height.

Fig 1: Identifying Secondary Latch
Courtesy of NISSAN MOTOR CO., U.S.A.
While operating the hood opener, carefully check that the front end of the hood is raised by approx. 20 mm (0.79 in). Also check that the hood opener returns to the original position.
Check the hood lock lubrication condition. If necessary, apply "body grease" to the points shown.
Install the front grille. Refer to "FRONT GRILLE ".

Fig 2: Locating Primary And Secondary Latch
Courtesy of NISSAN MOTOR CO., U.S.A.