LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2084 (Glass, Window System & Mirrors) >> Power Window System >> Door Switch Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Door Switch Check

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FRONT DOOR SWITCH INPUT SIGNAL 

    With CONSULT-III 

    Check front door switches ("DOOR SW-DR" and "DOOR SW-AS") in "DATA MONITOR" mode with CONSULT-III.

    FRONT DOOR SWITCH INPUT SIGNAL

    Monitor item Condition
    DOOR SW-DR OPEN: ON
    CLOSE: OFF
    DOOR SW-AS OPEN: ON
    CLOSE: OFF
    Fig 1: CONSULT-III Display - DATA MONITOR
    G04902773Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-III 

    Check voltage between BCM connector and ground.

    BCM CONNECTOR AND GROUND

    Item Connector Terminals Condition Voltage (V) (Approx.)
    (+) (-)
    Front RH M18 12 Ground OPEN 0
    CLOSE Battery voltage
    Front LH M19 47 OPEN 0
    CLOSE Battery voltage
    Fig 2: Checking Voltage Between BCM Connector And Ground
    G04902774Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Front door switch is OK.

    NG: GO TO 2.

  2. CHECK FRONT DOOR SWITCH CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect front door switch LH or RH and BCM connector.
    3. Check continuity between front door switch connector B8 (LH) or B108 (RH) terminal 2 and BCM connector M18 terminal 12 and connector M19 terminal 47.

      Front LH 2 - 47: Continuity should exist. 

      Front RH 2 - 12: Continuity should exist. 

    4. Check continuity between front door switch connector B8 (LH) or B108 (RH) terminal 2 and ground.

      2 - Ground: Continuity should not exist. 

      Fig 3: Checking Continuity Between Front Door Switch Connector Terminal 2 And BCM Terminal 47
      G04902775Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 3.

    NG: Repair or replace harness.

  3. CHECK DOOR SWITCH 
    1. Disconnect front door switch LH or RH.
    2. Check continuity between each front door switch terminal 2 and body ground part of front door switch.
      FRONT DOOR SWITCH TERMINAL 2 AND BODY GROUND PART OF FRONT DOOR SWITCH

      Terminal Door switch Continuity
      2 Body ground part of front door switch Pushed No
      Released Yes
      Fig 4: Checking Continuity Between Front Door Switch Terminal 2 And Ground
      G04902776Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Further inspection is necessary. Refer to SYMPTOM CHART .

    NG: Replace malfunctioning front door switch.