Front Power Window Motor RH Circuit Inspection

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH OUTPUT SIGNAL

Turn ignition switch ON.

Check voltage between power window and door lock/unlock switch RH connector D105 terminals 8, 9 and ground.

POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH CONNECTOR D105 TERMINALS 8, 9 AND GROUND

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D105	9	Ground	Closing	0
	9		Opening	Battery voltage
	8		Closing	Battery voltage
	8		Opening	0

Fig 1: Checking Voltage Between Power Window And Door Lock/Unlock Switch RH Connector D105 Terminals 8, 9 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2

NG: Replace power window and door lock/unlock switch RH. Refer to "FRONT DOOR ".

CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front power window motor RH and power window and door lock/unlock switch RH.
3. Check continuity between front power window switch RH connector D105 terminals 8, 9 and front power window motor RH connector D104 terminals 1, 2.
  8 - 1: Continuity should exist.
  
  9 - 2: Continuity should exist.
Fig 2: Checking Front Power Window Motor RH Circuit
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace front power window motor RH. Refer to "FRONT DOOR GLASS AND REGULATOR ".

NG: Repair or replace harness.