Front Power Window Motor RH Circuit Check

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH OUTPUT SIGNAL

Connect power window and door lock/unlock switch RH.
Turn ignition switch ON.

Check voltage between power window and door lock/unlock switch RH connector D105 terminals 8, 9 and ground.

TERMINAL VOLTAGE CONDITION CHART

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D105	8	Ground	Closing	Battery voltage
	8		Opening	0
	9		Closing	0
	9		Opening	Battery voltage

Fig 1: Checking Voltage Between Door Lock/Unlock Switch RH Connector D 105 Terminals 8, 9 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Replace power window and door lock/unlock switch RH. Refer to "FRONT DOOR ".

CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front power window motor RH and power window and door lock/unlock switch RH.
3. Check continuity between power window and door lock/unlock switch RH connector D105 terminals 8, 9 and front power window motor RH connector D104 terminals 1, 2.
  8 - 2 : Continuity should exist.
  
  9 - 1 : Continuity should exist.
OK or NG

OK: Replace front power window motor RH. Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace harness.