Symptom Chart
NOTE:
- Always check keyfob battery before replacing keyfob.
- The panic alarm operation and trunk lid opener operation of remote keyless entry system do not activate with the ignition key inserted in the ignition key cylinder.
- Use Remote Keyless Entry Tester J-43241 (follow instructions on tester) to check operation of keyfob before replacing keyfob.
PROBLEM SYMPTOM TABLE - REMOTE KEYLESS ENTRY SYSTEM
| Symptom | Diagnoses/service procedure |
|---|---|
| All function of remote keyless entry system do not operate. | 1. Keyfob battery and function check (use Remote Keyless Entry Tester J-43241) |
| 2. Replace keyfob. Refer to ID Code Entry Procedure.
NOTE:
If the result of keyfob function check with CONSULT-II is OK, Keyfob is not malfunctioning.
|
|
| The new ID of keyfob cannot be entered. | 1. Keyfob battery and function check (use Remote Keyless Entry Tester J-43241) |
| 2. Key switch (insert) check | |
| 3. Door switch check | |
| 4. Replace keyfob. Refer to ID Code Entry Procedure.
NOTE:
If the result of keyfob function check with CONSULT-II is OK, Keyfob is not malfunctioning.
|
|
| Door lock or unlock does not function. (If the power door lock system does not operate manually, check power door lock system. Refer to , "POWER DOOR LOCK SYSTEM ".) |
1. Keyfob battery and function check (use Remote Keyless Entry Tester J-43241) |
| 2. Replace keyfob. Refer to ID Code Entry Procedure.
NOTE:
If the result of keyfob function check with CONSULT-II is OK, Keyfob is not malfunctioning.
|
|
| Hazard and horn reminder does not activate properly when pressing lock or unlock button of keyfob. | 1. Hazard reminder check |
| 2. Horn reminder check | |
| 3. Door switch check | |
| 4. Replace BCM. | |
| Room lamp, ignition illumination and step lamp operation do not activate properly. | 1. Room lamp operation check |
| 2. Ignition illumination operation check | |
| 3. Step lamp operation check | |
| 4. Door switch check | |
| Panic alarm (horn and headlamp) does not activate when panic alarm button is continuously pressed. | 1. Keyfob battery and function check (use Remote Keyless Entry Tester J-43241) |
| 2. Vehicle security operation check. Refer to Vehicle security system. |
|
| 3. Key switch (insert) check | |
| 4. Replace keyfob. Refer to ID Code Entry Procedure.
NOTE:
If the result of keyfob function check with CONSULT-II is OK, Keyfob is not malfunctioning.
|
|
| Trunk lid does not open when trunk opener button is continuously pressed. | 1. Keyfob battery and function check (use Remote Keyless Entry Tester J-43241) |
| 2. Trunk release solenoid check | |
| 3. Key switch (insert) check | |
| 4. Replace BCM. |