Trunk Release Solenoid Check

CHECK TRUNK LID OPENER
Check trunk release operation with trunk lid opener switch.

NOTE: First check trunk lid opener cancel switch position. Refer to , "TRUNK LID OPENER ".

Does trunk lid open?

Yes: GO TO 2.

No: Check trunk release solenoid and the circuit.
CHECK TRUNK LID OPENER ACTUATOR OPERATION
With CONSULT-II
1. Select "ACTIVE TEST" in "MULTI REMOTE ENT" with CONSULT-II.
2. Select "TRUNK/BACK DOOR" and touch "ON".
  Trunk release solenoid should operate.
  
  NOTE: If CONSULT-II is not available, skip this procedure and go to the next step.
  
  Fig 1: CONSULT-II Display - Active Test
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK: Trunk lid opener actuator circuit is OK.

NG: Check harness for open or short between BCM and trunk lid opener actuator.
CHECK TRUNK LID OPENER ACTUATOR CIRCUIT
Without CONSULT-II
1. Disconnect trunk lamp switch and trunk release solenoid connector.
2. While pressing keyfob release button, check voltage between trunk lamp switch and trunk release solenoid harness connector B32 terminal 3 and ground.
  3 - Ground: Battery voltage should exist.
3. Check continuity between trunk lamp switch and trunk release solenoid harness connector B32 terminal 4 and ground.
  4 - Ground: Continuity should exist.
  
  Fig 2: Checking Trunk Lid Opener Actuator Circuit
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK: Replace trunk release solenoid.

NG: Check the following:
1. Harness for open or short between BCM and trunk release solenoid
2. Harness for open or short between trunk lamp switch and trunk release solenoid and ground
3. Replace BCM