Testing Condition:

• Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface.
• Always perform test at a temperature of 0 to 30°C (32 to 86°F).

1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
   Fig 1: CONSULT-II Display - Data Monitor

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Make sure that the following conditions are met.

   COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

   INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

5. Select "EVP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.

   Follow the instruction displayed.

   Fig 2: Consult-II EVAP SMALL LEAK Display Screen

   Courtesy of NISSAN MOTOR CO., U.S.A.
   NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-II screen, go to "BASIC INSPECTION ".
6. Make sure that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE "

Fig 3: CONSULT II Display - EVAP SML LEAK

Courtesy of NISSAN MOTOR CO., U.S.A.