LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U1000 To P0133 (Qr25DE) >> DTC P0011 IVT Control >> DTC Confirmation Procedure >> With Consult-II
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

With Consult-II

  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Maintain the following conditions for at least 6 consecutive seconds.

    Hold the accelerator pedal as steady as possible.

    CONDITION REFERENCE

    ENG SPEED 500 - 2, 000 rpm (A constant rotation is maintained.)
    COOLANT TEMPS 70 - 120°C(158 - 248°F)
    B/FUEL SCHDL More than 4 msec
    Selector lever P or N position (A/T) Neutral position (M/T)
    Fig 1: CONSULT-II Screen Display - DATA MONITOR
    G04191681Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Let engine idle for 10 seconds.
  5. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If the 1st trip DTC is not detected, go to next step.

  6. Maintain the following conditions for at least 6 consecutive seconds.
    CONDITION REFERENCE

    ENG SPEED 1, 800 - 3, 175 rpm (A constant rotation is maintained.)
    COOLANT TEMPS 70 - 105°C(158 - 221°F)
    Selector lever 1st or 2nd position
    Driving location uphill Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)
  7. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals