Component Function Check

With CONSULT-III 

1. Turn ignition switch ON.
2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
3. Check "BRAKE SW1" indication under the following conditions.
   FOR ASCD BRAKE SWITCH FUNCTION WITH CONSULT-III
   
   

   Monitor item	Condition		Indication
   BRAKE SW1	Brake pedal	Slightly depressed	OFF
   		Fully released	ON

Without CONSULT-III 

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground.
   FOR ASCD BRAKE SWITCH FUNCTION WITHOUT CONSULT-III
   
   

   ECM		Ground	Condition		Voltage
   Connector	Terminal
   E10	110 (ASCD brake switch signal)	Ground	Brake pedal	Slightly depressed	Approx. 0V
   				Fully released	Battery voltage

Is the inspection result normal? 

YES: INSPECTION END.

NO: Refer to "DIAGNOSIS PROCEDURE ".