Component Inspection

Without CONSULT-III 

1. Turn ignition switch OFF.
2. Disconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect electronic controlled engine mount purge hoses connected to electronic controlled engine mount control solenoid valve.
4. Check air passage continuity and operation delay time under the following conditions.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Condition	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
   12V direct current supply between terminals 1 and 2	Existed	Not existed
   No supply	Not existed	Existed

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace electronic controlled engine mount control solenoid valve.