April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "SPECIAL REPAIR REQUIREMENT ".
Turn ignition switch ON.
Set selector lever to D position.

Check the voltage between ECM harness connector terminals under the following conditions.

TERMINALS VOLTAGE REFERENCE

ECM				Condition		Voltage
+		-
Connector	Terminal	Connector	Terminal
F8	37 (TP sensor 1 signal)	F8	36 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36V
	37 (TP sensor 1 signal)				Fully depressed	Less than 4.75V
	38 (TP sensor 2 signal)				Fully released	Less than 4.75V
	38 (TP sensor 2 signal)				Fully depressed	More than 0.36V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".
  INSPECTION END