Inspection Procedure

1. Turn ignition switch OFF.
2. Connect GST to data link connector, which is located under LH dash panel near the hood opener handle.
   Fig 1: Identifying Brake Pedal And Data Link Connector

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Turn ignition switch ON.
4. Enter the program according to instruction on the screen or in the operation article.

   (*: Regarding GST screens in this part, sample screens are shown.)

   Fig 2: Generic Scan Tool Screen Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Perform each diagnostic mode according to each service procedure.

For further information, see the GST Operation Manual of the tool maker. 

Fig 3: Generic Scan Tool Display - READINESS TESTS

Courtesy of NISSAN MOTOR CO., U.S.A.