LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2011 >> Rogue S, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0340 - For CALIFORNIA >> DTC P0181: FTT Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK FUEL TANK TEMPERATURE SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect "fuel level sensor unit and fuel pump" harness connector.
    3. Remove fuel level sensor unit. Refer to " 2WD : REMOVAL AND INSTALLATION " (2WD models) or " AWD : REMOVAL AND INSTALLATION " (AWD models).
    4. Check resistance between "fuel level sensor unit and fuel pump" terminals by heating with hot water as shown in the figure.
    RESISTANCE REFERENCE CHART

    Terminals Condition Resistance (kΩ)
    1 and 2 Temperature [°C (°F)] 20 (68) 2.3 - 2.7
    50 (122) 0.79 - 0.90
    Fig 1: Checking Fuel Tank Temperature Sensor
    G07140826Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace "fuel level sensor unit and fuel pump". Refer to " 2WD : REMOVAL AND INSTALLATION " (2WD models) or " AWD : REMOVAL AND INSTALLATION " (AWD models).

scientia non olet · About LEMON Manuals