LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Keyless/Power Door Locks/Security System) >> Tailgate Outer Handle Switch Test/Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tailgate Outer Handle Switch Test/Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tailgate trim panel (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
  2. Disconnect the 3P connector (A) from the tailgate outer handle switch (B).
    Fig 1: Locating 3P Connector And Tailgate Outer Handle Switch
    G08055271Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between tailgate outer handle switch 3P connector terminals No. 2 and No. 3.
    • There should be continuity when the tailgate outer handle is pulled.
    • There should be no continuity when the tailgate outer handle is released.
  4. If the continuity is not as specified, remove the two bolts and replace the tailgate outer handle switch (A).
    Fig 2: Locating Bolts And Tailgate Outer Handle Switch
    G08055272Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the switch in the reverse order of removal.
scientia non olet · About LEMON Manuals