DTC Confirmation Procedure

CAUTION: Always drive at a safe speed.

NOTE:

If DTC P0011 is displayed with DTC P0075, first perform trouble diagnosis for DTC P0075. See DTC P0075 IVT CONTROL SOLENOID VALVE .
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle .

WITH CONSULT

Maintain the following conditions for at least 6 consecutive seconds.

Hold the accelerator pedal as steady as possible.

ENG SPEED	1, 200 - 2, 000 rpm (A constant rotation is maintained.)
COOLAN TEMP/S	More than 60°C (140°F)
B/FUEL SCHDL	More than 3.5 msec
Selector lever	P or N position (CVT) Neutral position (M/T)

Let engine idle for 10 seconds.
Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
If 1st trip DTC is not detected, go to next step.

Maintain the following conditions for at least 20 consecutive seconds.

ENG SPEED	1, 200 - 3, 175 rpm (A constant rotation is maintained.)
COOLAN TEMP/S	More than 65°C (149°F)
Selector lever	1st or 2nd position
Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
WITH GST

Follow the procedure "WITH CONSULT" above.