DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO 2.

1. Start engine and warm it up to normal operating temperature.
2. Drive the vehicle for at least 5 seconds under the following conditions:
   CAUTION: Always drive vehicle at safe speed.

   Selector lever	Suitable position
   Vehicle speed	40 km/h (25 MPH) or more

   NOTE:

   • The gear must be fixed while driving the vehicle.
   • Keep the accelerator pedal as steady as possible during cruising.
3. Check 1st trip DTC.

Is 1st trip DTC detected?

YES: Proceed to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END