LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2012 >> Versa SL, 4D Hatchback >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P050A To P2A00 (Hatchback) >> DTC P2138: App Sensor >> Component Inspection >> Accelerator Pedal Position Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Accelerator Pedal Position Sensor

  1. Reconnect all harness connectors disconnected.
  2. Turn ignition switch ON.
  3. Check voltage between ECM terminals 110 (APP sensor 1 signal), 103 (APP sensor 2 signal) and ground under the following conditions.
    Terminal Accelerator pedal Voltage
    110 (Accelerator pedal position sensor 1) Fully released 0.6 - 0.9 V
    Fully depressed 3.9 - 4.7 V
    103 (Accelerator pedal position sensor 2) Fully released 0.3 - 0.6 V
    Fully depressed 1.95 - 2.4 V
  4. If NG, replace accelerator pedal assembly. Refer to "REMOVAL AND INSTALLATION ".
    Fig 1: Checking Accelerator Pedal Position Sensor
    G08275709Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals