Inspection Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
- Fully understand the following items well before the road test;
- Precautions: Refer to "PRECAUTION FOR LDW SYSTEM SERVICE ".
- System description for LDW: Refer to "SYSTEM DESCRIPTION ".
- System description for BSW: Refer to "SYSTEM DESCRIPTION ".
- System description for MOD: Refer to "SYSTEM DESCRIPTION ".
- Handling precaution: Refer to "PRECAUTIONS FOR MOVING OBJECTS DETECTION ".
- CHECK LDW SYSTEM SETTING
- Start the engine.
- Check that the LDW system setting can be enabled/disabled on the vehicle information display.
- Turn OFF the ignition switch and wait for 30 seconds or more.
- Check that the previous setting is saved when the engine starts again.
: GO TO 2.
- ACTION TEST FOR LDW
- Enable the setting of the LDW system on the vehicle information display.
- Turn warning systems switch ON (warning systems ON indicator is ON).
- Check the LDW operation according to the following table.
Vehicle condition/Driver's operation Action Warning systems ON indicator Indication on the combination meter Buzzer Less than Approx. 60 km/h (40 MPH) Close to lane marker No action ON - Approx. 70 km/h (45 MPH) or more Close to lane marker Warning - Buzzer sounds
- Warning lamp blinks
ON Short continuous beeps - Close to lane marker
- Turn signal ON (Deviate side)
No action ON - NOTE: After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (40 MPH). Refer to "SYSTEM DESCRIPTION ".: Inspection End.