Inspection Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
- Fully understand the following items well before the road test;
- Precautions: Refer to "PRECAUTION FOR LDW SYSTEM SERVICE ".
- System description for LDW: Refer to "SYSTEM DESCRIPTION ".
- System description for BSW: Refer to "SYSTEM DESCRIPTION ".
- System description for MOD: Refer to "SYSTEM DESCRIPTION ".
- Handling precaution: Refer to "PRECAUTIONS FOR MOVING OBJECTS DETECTION ".
- CHECK MOD SYSTEM SETTING
- Start the engine.
- Check that the MOD system setting can be enabled/disabled on the vehicle information display.
- Turn OFF the ignition switch and wait for 30 seconds or more.
- Check that the previous setting is saved when the engine starts again.
: GO TO 2.
- ACTION TEST FOR MOD
- Enable the setting of the MOD system on the vehicle information display.
- Turn warning systems switch ON (warning systems ON indicator is ON).
- Check the MOD operation according to the following table.
Vehicle condition/Driver's operation Vehicle response Moving Object Detection ON indicator Vehicle speed (Approx.) [km/h (MPH)] Status of vehicle detection within detection area Indication on the Moving Object Detection indicator Buzzer OFF - - OFF OFF Blue Less than approx. 8 km/h (5 MPH) Vehicle is detected ON ON Approx. 8 km/h (5 MPH) or more Vehicle is absent ON OFF Vehicle is detected ON OFF Vehicle is not detected ON OFF NOTE: After the operating conditions of warning are satisfied, the warning continues until the vehicle reaches a higher speed. Refer to "SYSTEM DESCRIPTION ".: Inspection End.