April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ". Refer to "WORK PROCEDURE ".
Turn ignition switch ON.
Set selector lever to D (CVT) or 1st (M/T) position.

Check the voltage between ECM harness connector terminals as per the following conditions.

ECM			Condition		Voltage
Connector	+	-
Connector	Terminal
F26	75	74	Accelerator pedal	Fully released	More than 0.36V
	75			Fully depressed	Less than 4.75V
	76			Fully released	Less than 4.75V
	76			Fully depressed	More than 0.36V

Is the inspection result normal?

YES: INSPECTION END

NO: Replace electric throttle control actuator. Refer to "EXPLODED VIEW ".