Power Supply Position Change Table By Push-Button Ignition Switch Operation
VEHICLE SPEED: LESS THAN 4 KM/H (2.5 MPH)
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| CVT models | M/T models | |||
| Selector lever | Brake pedal operation condition | Clutch pedal operation condition | ||
| OFF → ACC | - | Not depressed | Not depressed | 1 |
| OFF → ACC → ON | - | Not depressed | Not depressed | 2 |
| OFF → ACC → ON → OFF | - | Not depressed | Not depressed | 3 |
| OFF → START ACC → START ON → START |
P or N position | Depressed | Depressed | 1 |
| Engine is running → OFF | - | - | - | 1 |
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, they are equivalent to the operations below.
- When starting the engine, the BCM monitors the engine start conditions as per the following,
CVT models
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
M/T models
- Clutch pedal operating condition
- Vehicle speed
VEHICLE SPEED: 4 KM/H (2.5 MPH) OR MORE
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| CVT models | M/T models | |||
| Selector lever | Brake pedal operation condition | Clutch pedal operation condition | ||
| Engine is running → ACC | - | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | Depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.