Work Procedure

WRITING MODE SELECTION
CONSULT Configuration

Select "Re/programming, Configuration" of air bag.

When writing saved data

GO TO 2.

When writing manually

GO TO 3.
PERFORM "AFTER REPLACE ECU" OF "READ / WRITE CONFIGURATION"
CONSULT Configuration

Perform "After Replace ECU" of "Read / Write Configuration".

GO TO 4.
PERFORM "MANUAL CONFIGURATION"
CONSULT Configuration
1. Select "Manual Configuration".
2. Touch "Next".
3. Select the "Type ID" searched by using FAST (service parts catalogue) to write the "Type ID" into the air bag diagnosis sensor unit.
4. Touch "OK".
5. Check that the configuration has been successfully written and touch "End".
GO TO 4.
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON.
4. Check that all ECU self-diagnosis results have no DTC.
WORK END