Code B111, A/C High Side Temperature Sensor CKT (TORONADO): Notes

The A/C high side temperature sensor is a thermistor that controls the signal voltage to the BCM. The BCM applies a voltage on circuit No. 732 to the sensor. When the sensor is cold, its resistance is high, therefore, the BCM will see a high signal voltage. As the sensor warms, its resistance becomes less and the signal voltage is pulled low through the sensor ground, circuit No. 736. This signal voltage will vary between 5 volts (open circuit) and 0 volts (shorted circuit).

Code B111 will set if the ignition is on, the outside temperature sensor has not failed and reads above 32°F, and the signal voltage indicates less than -24°F (open circuit) or over 409°F (shorted circuit). During the time the failure is present, a substitute temperature reading will be implemented to allow continued operation of the climate control system and the engine cooling fans will be forced to high speed if the A/C clutch is on. The A/C high side temperature reading BD27 will, however, display the actual sensor reading.

1. BCM data value BD27 displays A/C high side temperature. The normal range is from -24° to 409°F.
2. Checks to see if the open circuit reading is due to the circuit or the sensor. If the open circuit reading changes to a shorted circuit reading after jumping the sensor terminal, the BCM and wiring are okay.
3. By applying a ground to various points in the circuits, an open can be isolated by observing whether the parameter display can be changed from the open reading to the shorted reading.
4. Checks to see if the shorted circuit reading is due to the circuit or the sensor. If the shorted circuit reading changes to an open circuit reading after disconnecting the sensor, the BCM and wiring are okay.