Valve Block Assembly
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1988 Oldsmobile Ninety-Eight, 1988 Oldsmobile Delta 88, 1987 Oldsmobile Ninety-Eight, 1987 Oldsmobile Delta 88, and 1986 Oldsmobile Ninety-Eight. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Before servicing any component which contains high pressure, it is mandatory that hydraulic pressure in the system be discharged. With ignition off, pump brake pedal a MINIMUM of 20 times using full pedal strokes. When a definite increase in pedal effort is felt, pump pedal 2 more times.
Disconnect negative battery cable. Depressurize brake system. Remove fluid from reservoir. Remove hydraulic unit. Remove 3 nuts and washers. Remove valve block assembly and "O" rings. To install, reverse removal procedure. Inspect "O" rings and replace if necessary. See BLEEDING BRAKE SYSTEM in this article.