Throttle Position Sensor: Service and Repair

Throttle Position Sensor Service:

REMOVAL

1. Disconnect electrical connector.
2. Remove PVC vent hose.
3. Remove two TP sensor attaching screws.
4. Remove sensor.

INSTALLATION

1. With throttle valve in the normal closed idle position, install Throttle Position (TP) sensor on throttle body assembly, making sure TP sensor pickup lever is located ABOVE tang on throttle actuator lever.
2. Install two TP sensor screws using a thread locking compound on the screws, Loctite 262 or equivalent should be used.
3. Reconnect electrical connector.