Ignition Control Module: Service and Repair

Ignition Control Module And Coil Assembly:

Ignition Coils And Ignition Control Module:

REMOVE OR DISCONNECT
1. Disconnect 14 way connector at ignition control module.
2. Remove spark plug wires from coil assemblies.
3. Remove 6 screws securing coil assemblies to ignition control module.
4. Disconnect coils from ignition control module.
5. Remove nuts and washers securing ignition control module assembly to bracket.
6. Remove ignition control module.


INSTALL OR CONNECT
1. Install coils to ignition control module.
2. Install and tighten 6 screws, Torque to 4-5 Nm (40 lb.in).
3. Install and tighten nuts and washers securing assembly to bracket. Torque to 8 Nm (70 lb.in).
4. Connect spark plugs wires.
5. Connect 14 way connector to module.