LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 1997 >> Eighty-Eight Base >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specs & Procedures >> Specifications Index
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Specifications Index

BONNEVILLE, EIGHTY-EIGHT, EIGHTY-EIGHT LS, REGENCY, LESABRE SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
Service
Automatic A/C SYSTEM SPECIFICATIONS
Manual A/C SYSTEM SPECIFICATIONS
Torque
Automatic TORQUE SPECIFICATIONS
Manual TORQUE SPECIFICATIONS
Axle Nut/Hub Nut 107 Ft. Lbs. (145 N.m)
Battery BATTERY SPECIFICATIONS
Brakes
Bleeding Sequence RR, LR, RF, LF
Disc Brakes
Service Specifications DISC BRAKE SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Drum Brakes
Service Specifications DRUM BRAKE SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Charging
Generator See Table under DESCRIPTION
Torque TORQUE SPECIFICATIONS
Drive Belts
Adjustment BELT ADJUSTMENT
Drive Belt Routing See appropriate figure under SERPENTINE BELT ROUTING
Engine Cooling
General Service Specifications COOLING SYSTEM SPECIFICATIONS
Radiator Cap Pressure 15 psi
Thermostat R & I THERMOSTAT
Water Pump R & I WATER PUMP
Engine Mechanical
Compression COMPRESSION
Oil Pressure 60 psi (413.7 kPa) at 1850 RPM with 5W-30 or 10W-30 engine oil
Overhaul ENGINE SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque
Step 1 11 Ft. lbs. (15 N.m)
Step 2 Additional 50 Degrees
Fuel System
Pressure Specification 48-55 psi (331-379 kPa)
Fuel Pressure Test Procedure FUEL SYSTEM PRESSURE TEST
Fuel Filter Location In-Line fuel filter is on right side
Fuel Filter R & I IN-LINE FUEL FILTER
Ignition
Firing Order & Cylinder Identification FIRING ORDER
Ignition Wires (Resistance) 30,000 Ohms Maximum
Ignition Wires (Routing) See figure under FIRING ORDER
Spark Plug
VIN K
Type 41-606
Gap .060 In. (1.52 mm)
Torque 11 Ft. lbs. (15 N.m)
VIN 1
Type 41-601
Gap .060 In. (1.52 mm)
Torque 11 Ft. lbs. (15 N.m)
Starting
Starter STARTER SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Wheel Alignment
Adjustment Specifications WHEEL ALIGNMENT SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Wheel & Tire
Wheel Lug Nut Torque 100 Ft. Lbs. (136 N.m)