Cruise Control Release Switch/Stoplight Switch
WARNING: This page is about a different car, the 1997 Oldsmobile Aurora and 1997 Buick Riviera. However, it is still accessible from the selected car via links, so may be relevant.
- Brake booster pushrod must be assembled to brake pedal before cruise control release switch/stoplight switch can be adjusted. Insert release switch/stoplight switch into retainers until fully seated against brake pedal bracket. Twist switch clockwise about 60° until travel stop is reached. When switch is fully locked, electrical connector should face 3 o'clock position.
- Measuring pedal travel from centerline of brake pedal, ensure release switch/stoplight switch contacts are open by 1/8-1/2" (3.5-12.5 mm) of pedal travel. Nominal actuation of stoplight switch contacts is approximately 3/16" (4.5 mm) after release switch contacts close. Check brakelights for proper operation.