All Memory & Seat Functions Inoperative
NOTE:
After repair or component replacement is completed, perform appropriate MEMORY SYSTEM CHECK under TROUBLE SHOOTING
to verify system is functioning properly.
- Perform appropriate MEMORY SYSTEM CHECK under TROUBLE SHOOTING . Go to next step.
- Disconnect memory seat/mirror module Black, 2-pin connector C2. Using DVOM connected to ground, measure voltage at memory seat/mirror connector C2, terminal "A" (Orange wire). If 10-15 volts exists, go to next step. If 10-15 volts does not exist, go to step 5).
- Connect DVOM between memory seat/mirror module connector C2, terminals "A" (Orange wire) and "B" (Black wire). If 10-15 volts exists, go to next step. If 10-15 volts does not exist, go to step 6).
- Replace memory seat/mirror module.
- Repair open in Orange wire between memory seat/mirror module and splice S339.
- Repair open in Black wire and memory seat/mirror module and splice S290.