EEPROM Programming

1. Set-up - Ensure that the following conditions have been met:
^ The battery is fully charged.
^ The ignition is ON.
^ The Tech line equipment cable connection at the DLC is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Tech line equipment user's instructions.
3. If the PCM fails to program, proceed as follows:
^ Ensure that all PCM connections are OK.
^ Check the Techline equipment for the latest software version.
^ Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. You must program the replacement PCM.

Functional Check
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and the engine run for one minute.
3. Use the scan tool in order to scan for the DTCs.
4. If DTC P0325 sets, the KS module is not fully seated, is missing, or is malfunctioning.