Memory Seat Set With Keyless Entry Transmitter

When a keyless entry transmitter is used to unlock the vehicle's doors, the Remote Function Actuator (RFA) module communicates the unlock command and which driver performed the command to the memory seat/mirror module via CKT 1985 (PPL). Each keyless entry transmitter is programmed with one of 4 personalized recall options when the RFA receives an unlock message:

1. Mode 0
   
   The memory seat/mirror module sounds a single beep and the left seat will not move.
2. Mode 1
   
   The memory seat/mirror module sounds a single beep and the left seat and both mirrors will move to the position stored for DRIVER-1.
3. Mode 2
   
   The memory seat/mirror module sounds a single beep and the left seat and both mirrors will move to the position stored for DRIVER-2.
4. Mode 3
   
   The memory seat/mirror module sounds a single beep and the left seat will move to the easy exit position which is fully back and down.

Perform the following procedure in order to program a keyless entry transmitter for a specific mode:

1. Mode 0
   
   Press the SET MEMORY button on the left seat switch. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
2. Mode 1
   
   Perform a memory set function for DRIVER-1. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
3. Mode 2
   
   Perform a memory set function for DRIVER-2. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
4. Mode 3
   
   Perform one of the 3 following procedures in order to set the keyless entry transmitter to this mode:
   • Perform an easy exit function. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
   • Press the UNLOCK button on the keyless entry transmitter. Within 5 seconds, press the DRIVER-1 and DRIVER-2 buttons simultaneously.